Subject: | |
From: | |
Reply To: | |
Date: | Tue, 18 May 1999 10:40:01 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello there,
I have requirements to trim leads down to 0.035". Have anybody try to prep that short before wave. Board
size is 4"x6" . I would like to know if any experience with machines that trim leads.
Fikreta Jusufagic
Mfg. Engineer
Sanmina Co, San Jose
Voice: (408) 954-5594
Fax: (408) 954-5277
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|