Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Sat, 8 May 1999 19:20:41 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Along the lines of Dave's reply: IPC had difficulty finding current photographs of boards with a soda
straw defect for the IPC-A-600 certification program.
Don Vischulis
Dave Hoover wrote:
> Soda Strawing....back in my day....Hehehe...meant a
> small air pocket located along the trace edge(s) under
> the soldermask (or flex covercoat). When parts were
> wet processed or fluxed with, or followed by heat,
> the corrosive chemistry(s) would wick up along the
> traces and create problems. This is more prevalent
> with overplated traces and dryfilm soldermasks.
> SIC values can be really high because the solutions
> can leach out during SIC testing. Issues like that
> could result in a latent failure of the copper
> conductors under the soldermasks (covercoats).
> With the advent of LPI Soldermask I haven't heard
> about this for a LONG....LONG time.
>
> Good Luck.
>
> Groovy
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|