Hello Technetters,
Many thanks for the help with AutoCAD to dot.PDF conversion.
Here is another item which puzzles me ....
Is there a recognized standard for orientation of top-mark with respect to the
pin-1 corner of the package (or ball A1 in the case of BGAs)?
What is the spec?
If it exists why do some vendors not comply with it?
Again thank you for your past help,
Tom
____________________________________________________________________
Get free e-mail and a permanent address at http://www.netaddress.com/?N=1
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################