Hi Everybody,

I was wondering if anybody could give me some leads on a versatile
microsectioning system?

I'm looking for a system which allows accurate microsections without needing
to route the board or drill it for the registration pins.

What's a reasonable accuracy? I don't really know  *2 mils?  *1 mil.
Accuracy that doesn't add a zero to the price.

Ideally, I need something that could do cross,  z axis or angled sections.
By z axis I mean similar to what they did for the Body Voyage CD-ROM (not to
gross anybody out).

Thanks,

Hans

Air Force Material Command - We keep them flying!
~~~~~~~~
Hans M. Hinners                                 WR-ALC/LYPME Bldg. 640
Materials Engineer                                      380 Second Street,
Suite 104
Manufacturing Eng. Sec.                         Robins AFB GA 31098-1638
912-926-1970 (Voice) 468 - 1970 (DSN)   912-926-7974 (Fax)
[log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################