TECHNET Archives

April 1999

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
"Stephen R. Gregory" <[log in to unmask]>
Reply To:
Date:
Thu, 8 Apr 1999 16:58:18 EDT
Content-Type:
text/plain
Parts/Attachments:
text/plain (51 lines)
In a message dated 4/8/99 1:19:50 PM Pacific Daylight Time,
[log in to unmask] writes:

<< Guys (and girls),

 Can anyone tell me whether or not polyimide boards need to be pre-baked
 before processing thru nitrogen reflow for solder melt?  We are doing it,
 which of course means added expense.  Is it really necessary?  We bake at
 110 C for four hours.  Is there evidence which suggests that it is
 necessary.
 Thanks for any replies,

 Bill Mengers
 Northrop Grumman Corp.
 Baltimore, Md. >>

Hello Bill!

      I can't think of any reason that you would HAVE to bake your boards
before processing. From my experience, I would bake boards if I were having
problems with entrapped moisture that outgases during wave solder giving me
blowholes, voids, etc..

      But even then, I wouldn't do it as a matter of course. The way I would
do it is; say I'd start waving a lot of PCB's, and if on the first few I see
blowholes and whatnot, I'd stop waving the assemblies, and then roll the
carts into a burn-in room to stay for about 3-4 hours to get rid of the
moisture. If I had a history of the FAB's being full of moisture from a
certain vendor, then I might bake them as a standard procedure until I
started getting boards that didn't.

      Bottom line in my opinion, you should get boards that are ready to rock
and roll as soon as you get them...you shouldn't have to bake anything unless
you're having some sort of problems. Baking increases the oxidation of your
solderable surfaces and may give you other problems...don't do it unless ya'
hafta...

-Steve Gregory-

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################


ATOM RSS1 RSS2