Is there anyone out there who has experience reflowing ceramic boards in a
forced convection oven using Sn96.5/Ag3.5 solder paste w/WS flux?
The boards I am working with are an array about 4.5" x 4.5" x .040 thick
with 16 each .6 x .6 daughterboards spaced out across the panel.
I'd like a few minutes of phone time with someone who has had experince
profiling one of these. If you would care to send your phone number, I'll
give you a buzz.
Thanks in advance.
Charlie B.
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################