From: Dennis J Fall@TFT on 03/09/99 03:11 PM
To: [log in to unmask]
cc:
Subject: Etchant for Copper Assuming Sn/Pb Resist
Where (if anywhere) can I get an etching chemistry that will remove
approximately 1000-3000 angstroms of copper, but will not harm
electroplated Sn/Pb? If possible, I would also like to remove 1000-3000
angstroms of Nickel-Chromium that is under the copper at the same time I
remove the copper. I will greatly appreciate any help.
Thank You
Dennis Fall P: 507-625-8445 x17
Engineer F: 507-625-3523
Thin Film Technology Corporation
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################