Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 1 Mar 1999 14:42:18 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
My model, derived from IPC-TR-579, uses pi/4 * [(Tpwb + Dptv)^2 - (Dptv)^2]
as the area of influence of the epoxy on the PWB. Tpwb is the PWB
thickness and Dptv is the drilled PTV diameter.
This is the area of a ring that battles against the PTV barrel's
cross-section in the stress equation.
It assumes a certain uniform heat penetration depth and [If I remember
correctly] doesn't model the extra heating gained by lots of innerlayer
copper pads (see Werner's post from 2/25/99). Be careful if you're doing
transient analysis - perhaps you could calculate an 'epoxy/glass lumped
capacitance time constant' and base this penetration depth on the thermal
heating rate...
J.Felts
-----Original Message-----
From: Michael Blattau [SMTP:[log in to unmask]]
Sent: Monday, March 01, 1999 12:03 PM
To: [log in to unmask]
Subject: [TN] PTV/PTH model
What the most common thickness that is usually used for the resin rich
region surrounding a PTH (worst case/best case scenarios). I'm working on
a 3-D Electro-Thermal FEA model.
Thanks,
Mike
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|