Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 17 Feb 1999 07:38:54 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi,
I have a requirement on a design to make a conductor trackwork to take
50Amps AC/DC continuous at 50Hz.
Two questions:
1. What would the cross sectional area have to be to allow this, (and
work!) based on 1 oz plated trackwork, and 2 oz plated trackwork?
2. What heat rise would I expect to see on the PCB? Is there a table, or
correlation between heat rise and amperage that I can get a hold of?
Best regards,
Colin William
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|