Bev- Iomega used to use something very similar in one of their designs,
only they used conductive paint over copper. Sigma Circuits in
California was the company that produced a lot of the boards for them at
that time- you might check with them.

> Bill Davis, Ph.D.
> Diamond Multimedia Systems
> Senior Scientist
> Tel. 408.325.7868
> Cell. 408.888.5650
> e-mail: [log in to unmask]
>
>


-----Original Message-----
From: Bev Christian [mailto:[log in to unmask]]
Sent: Thursday, February 11, 1999 9:24 AM
To: [log in to unmask]
Subject: [TN] Contact Force/Pressure


TechNetters,
This came from one of my lab customers.  Any info you can give me to
pass
along?  Thanks
Bev Christian
Nortel Networks

We have a design for an "encoder gear" assembly, it is essentially a
gear
with some contact fingers (aka wiper arm) staked onto the gear. The
wiper
arm is made from one solid piece.  Once in the final assembly the gear
is
driven by an outside motor, the wiper arm fingers are in contact with
traces on a PCB.  As the gear is rotated the wiper arm  will result in
various outputs  as the traces are shorted to the inner ground
connection.
There are four outputs, one ground and three position outputs.  Each of
the
four finger tips is bifurcated.  The traces on the circuit board are
gold
plated with an approximate thickness of 40 microns, under the gold the
is a
nickel/ cobalt plating.

We have been experiencing great heartache due to intermittence as the
wiper
arm is rotated.  The intermittencies cause false outputs which cause our
tester to fail modules.  We have done many experiments to ensure that
the
PCB traces are sufficiently clean.  We know must look at the system
design.

The information I am seeking is whether there are specifications or
guidelines  for the necessary  or recommended contact pressure between
the
wiper fingers and the PCB traces to ensure reliable continuity.  I have
looked through the IPC manuals we have and found nothing.

I would imagine that this type of information would apply to
potentiometer
and very low current switch manufacturing.

I would be very grateful if you knew of any information on this subject
or
knew where I should look.

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV
1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################