In a message dated 2/8/99 7:46:26 AM Pacific Standard Time,
[log in to unmask] writes:

<< Hi Technetters,

 I am wandering if the component, such as Tantulum Capactor, is being
 45 degree angle by a Fuji CP4 machine, shoud the machine discard the
 part, or should it tries to adjust and make correction to the component's
 placement angle,  or what ...???


 Could someone advise me. Thanks.

 Poh >>

Hi Poh,

     I'm assuming that you're asking if a part was picked at a 45-degree
angle, would it correct the angle and place it...the last time I worked with a
CP-IV, if a part was out more than 30-degrees before it came to the camera, it
would reject it. But that's been a few years back...

-Steve Gregory-

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################