Good morning,

I must have missed part of this discussion, so ...(apologies)..., but where
is this model defined or described?

Ahne Oosterhof,
A-Laser, Inc (503)641-9428

-----Original Message-----
From:   TechNet [mailto:[log in to unmask]] On Behalf Of Werner  Engelmaier
Sent:   Wednesday, February 03, 1999 14:18 PM
To:     [log in to unmask]
Subject:        Re: [TN] Solder Paste volume Standards

Hi Richard,
Well, this notion may come from the Engelmaier-wild solder joint reliability
model for leaded components, where the stencil thickness appears in the
equation. This model appears imn a number of IPC documents. However, I can
tell you that this parameter is in the equation much more as a parameter to
balance the unit rather than a variable to actively influence reliability.
Also at the time of the development of the model, only 10 and 8 mil stencils
were in use.

Werner Engelmaier
Engelmaier Associates, L.C.
Electronic Packaging, Interconnection and Reliability Consulting
7 Jasmine Run
Ormond Beach, FL  32174  USA
Phone: 904-437-8747, Fax: 904-437-8737
E-mail: [log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################