Hello All
We have to characterize new plasma machine for PC board desmear / etchback
processing.
One of the plasma equipment manufacturer is proposing to us new plasma
etching system based on high RF frequency of 13.56 MHz, this system should
give us faster etch rates (comparing to 40 KHz system) but on the opposite
we understood from others that it is difficult to make tuning & power
matching to ensure less robust process.
Second subject: Regarding the gas that used for etching, Is someone has
experience with using NF3 for desmear / etchback processes as a replacement
to CF4/O2 gases ?
We will appreciate any comments.
Shabtay
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################