Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 9 Feb 1999 10:10:55 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Thanks to all of you that took the time to look into the problem I
had with the IPC calculator. I think Jeff could be right about FR4
being heavier than ohms/impedance so the numbers were higher on top...
I just wanted to flag everyone that what I found is not out of the
ordinary. Pick a calculator and use it, then go to the FAB shop and
give them your numbers to start with. Then use what they give you...
They know what works for them and take what you give them as a starting
place. Again, thanks to those that responded and remember these words:
"Never Forget".....
--
Scott Decker
Senior PCB Designer
AKA: PadMasterson
E-Mail: [log in to unmask]
-----------------------------------------------------------------
^
^^^ Praegitzer Design - A Division of Praegitzer Industries
^^^^^ 7245 N.W. Evergreen Pkwy, Suite 100, Hillsboro, OR 97124
^^^^^^^ Phone #: (503) 531-2050 Ext. 1820 Fax #: (503) 531-2051
Check out our WEB site at http://www.pii.com
-----------------------------------------------------------------
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|