Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 1 Feb 1999 10:43:45 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Brigitte,
You might consider PanelMaster 2.1 . Runs well on Windows 95/98/NT. Provides
for rotations within the array, rotations of the array with your production
panel, complete flexibility for image stepping (rout profile versus v-score
or combinations thereof) and places assembly rails on any number of
sides/any size (when configuring palletized arrays). You can also create
templates that automatically subtract plating theiving and tooling hole
locations so as to yield a net usable area, and the software prints
panel/array views complete with stats of percent usage. Did I mention it's
inexpensive?
If this hits the spot try:
STS (Southern Technical Sales)
PO Box 500037
Atlanta, GA 31150
tel: 770.390.0203 fax: 770.390.0913
Cheers!
Bob Lazzara
Circuit Connect Tech Support
Georgia Service Bureau
TEL: 800.560.9457 FAX: 888.453.0520 BBS: 603.889.5385
alternate eMail: [log in to unmask]
-----Original Message-----
From: Brigitte Haugk <[log in to unmask]>
To: [log in to unmask] <[log in to unmask]>
Date: Monday, February 01, 1999 10:08 AM
Subject: [TN] optimizing laminate usage
>To optimize the usage of laminate, we are looking for a software that can
>properly lay out a panel with the least amount of waste of laminate. Any
>recommendations?
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe: SUBSCRIBE TechNet <your full name>
>To unsubscribe: SIGNOFF TechNet
>################################################################
>Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
>For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
>################################################################
>
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|