Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 17 Feb 1999 06:17:00 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
TechnoWizards:
Has anyone out there used Omikron or Dexcoat as an etch resist? What
finish comes out of the etcher?
What is the expected rate of nitric based stripping for the series Omikron
: Electroplated Matte Tin : Electroplated Bright Tin? An answer as
quantitative as possible is sought.
[This is a personal question wrought from freedom of speech, and no intent
to upset any group was intended. Further, any wild response to this
message will be appropriately viewed and possibly not answered. Reading
the name and address below is an informal confirmation that you agree to
these terms of free speech and absolve the author - personally - of any
oversight or offensive statement.]
Thanks,
Paul Wilson
R&D Manager / Plant Chemist
Circuit Center, Inc.
4738 Gateway Circle
Dayton, OH 45440
Phone (937) 435-2131 Fax (937) 435-7698
http://www.circuitcenter.com
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|