Hi there,
Can anyone comment on the validity of a stripline Zo calculation when
the layer in question resides between a plane and another signal layer
and then a plane, instead of between two planes? The intent of the
designer was to ignore the adjacent signal layer. Fab guys: is this
acceptable when you have to meet a certain spec?
Thanks,
Dave
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################