TechNet,

Opinions requested.

I have some PWAs (assembled) that had rails added to the PWB for processing
purposes.  These were to be removed but were not.  The CM indicates they
will route them off.

I am very concerned about the effect vibration will have on the components
and general ESD/Debris control relative to the PWA.

IPC-D-279 mentions vibration and shock as things to be aware of, and in
Section 7.7 says that either
"snap" tabs or "full board routing" can be done.

Is routing a normal/acceptable method given the vibration of the PWA?

Any info appreciated.

Tks.......DT

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################