John,

Have you tried Equipto?  They can be reached at 708 897-4691.  They
manufacture rack systems and can often customize per your requirements.
Good luck!

Chad Thibodeau
Component Engineer
[log in to unmask]
2114 W. 7th Street
Tempe, AZ 85281
P-602 333-2138
F-602 921-9012
http://www.efdata.com

> -----Original Message-----
> From: John Lennox [SMTP:[log in to unmask]]
> Sent: Wednesday, January 13, 1999 3:39 PM
> To:   [log in to unmask]
> Subject:      [TN] Fab: Panel Racks
>
> TechNet:
>
> I am looking for a source of racks for bare boards up to a panel size of
> 18"x24".
> They need to hold the panels horizontally and be small enough for one
> person to lift them into an oven. Ideally, they would hold between 15 and
> 20 panels.
>
> I have seen some larger horizontal racks that have spring hinges on one
> side, where the operator initially lifts all of the racks, and begins
> filling from the bottom - flipping down the next rack as they go.
> This system would be ideal if it was small enough to be lifted.
>
> Any sources of information would be appreciated.
>
> Thanks,
> John Lennox
> EMC
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> To subscribe:   SUBSCRIBE TechNet <your full name>
> To unsubscribe:   SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
> section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or
> 847-509-9700 ext.312
> ################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################