I deal with a lot of people who do the smt then run the through hole over
the wave in a pallet that covers the smt parts. This saves a lot of time
compared with hand soldering, and the through gets more consistent soldering
results. Give me a buzz if you'd like to know more.
Jim Gleason@972-494-1911
-----Original Message-----
From: Bryan Bloom <[log in to unmask]>
To: [log in to unmask] <[log in to unmask]>
Date: Friday, January 15, 1999 4:39 PM
Subject: [TN] double sided, mixed media boards


>We are assembling a small, panelized board that has all surface mount
>components on one side and all through-hole components on the other side,
>thus all solder is on one side of the board.
>
>There are 9 through-hole components on each board and there are 16 boards
>per panel.  Besides doing the SMT first and then coming back and hand
>soldering the through-hole parts, how are other people doing this?  Does
>anyone do the through-hole first and come back and do the SMT later?  If
>so, are you using a fixture to cover the pads for the SMT parts, or do you
>mask, etc?
>
>Suggestions and comments are greatly appreciated.
>
>Please email response to [log in to unmask]
>
>Thanks!
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe:   SUBSCRIBE TechNet <your full name>
>To unsubscribe:   SIGNOFF TechNet
>################################################################
>Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
>For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
>################################################################
>

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################