Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 8 Jan 1999 11:25:47 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We have the wonderful challenge of ramping up quickly to
build rigid-flex assemblies in the 1,000 to 6,000 per month quantities.
Serious concerns are the proper handling, testing, and de-paneling.
I looked in the archives, but didn't see specific suggestions in these
areas. (I may have missed them if they are there.)
Is there a router/depaneler out there that is good at depanelling R-F
assemblies with parts on both sides, including up to 1/2" long
swaged standoffs?
TIA
Charlie Barker
Input/Output, Inc.
281-552-3328 Voice
281-552-3100 FAX
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|