Hi everybody,
I have been following this RF Material stuff but I don't understand anything about RF35 and Roger 4003 manufacturing codes. I am a design engineer and the last design we are working on uses RF at 418MHz. Does standard FR4 material will work fine? Is there any consideration I should take care of when contacting a board manufacturer?
thanks
Yvon Hache
Design Engineer
Concept + Inc.
Tel: 506-863-2467
Fax: 506-858-4075
email: [log in to unmask]
web: www.concept-plus.com
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################