Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 14 Jan 1999 14:37:13 +1100 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Earl , would you drill the chip or the card ?
I just thought if you'd make 1/2" went hole you'd alter the thermal mass and
flow readings ; apart from the Azteque ritual ?
To prick (and save) the card could do ? Seal if you bottom chill on way ?
paul
> ----------
> From: [log in to unmask][SMTP:[log in to unmask]]
> Sent: Thursday, 14 January 1999 13:44
> To: [log in to unmask]
> Subject: [TN] BGA and profiling
>
> John,
>
> Saw your question about BGA. I'm not sure about your definition of
> "balls." Do you mean
> eutectic solder balls?
>
> When it comes to placement, most folks always use solder paste no matter
> if the balls are
> eutectic or high temperature types. Is this where you are going? Just need
> clarification.
>
> As for thermocouples, I use a test board to set profiles for first time
> BGA's as I'm sure you
> do. For optimum placement for the most revealing and accurate readings,
> drill a hole in one
> or several BGA holes and insert the couples in them and measure temps "in
> the solder joint"
> as it is being formed during reflow.
>
> Earl Moon
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
> section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or
> 847-509-9700 ext.312
> ################################################################
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|