Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 15 Dec 1998 13:28:54 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hello Technetters,
I have couple of questions for Entek coated boards I am running on sample
basis.
(1) Do I need to apply solder paste on mounting holes of Entek coated
boards? These mounting holes will be used to fasten the board in a
chassis. Give me your pros and cons.
(2) The boards do have press fit connectors. Do you think I will be OK
with the Entek coating as connectors now will be making a contact
with copper which will get oxidized. Any long term problem from
reliability point of view. Can anyone suggest any test to find any
long-term reliability problem because of press-fit connector going
onto the bare copper?
re,
Ken Patel
______________________________________________________
Ken Patel Phone: (408) 490-6804
1708 McCarthy Blvd. Fax: (408) 490-6859
Milpitas, CA 95035 Beeper: (888) 769-1808
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|