Anne,
        Call your customer and get a part number for the mating connector.
Then, look up it's data sheet (many are available on the internet as pdf
files). The
data sheet should have the contact pitch dimensioned, as well as the slot
opening
and keying information. Some go so far as to put in suggested layouts.
        I remember the two basic edge finger patterns as being 0.100"
centers
and 0.156" centers. If it were me, I'd look it up.

 Michael Hiteshew
 Lockheed Martin Launching Systems
 [log in to unmask]
 (410) 682-1259


> To All,
>
> We have a customer that just dug up an old wire wrap board that they
> need.  It is an old "Scanbe" style board but they have nothing but a
> paper drawing.  No files or artwork and the dimensioning of the finger
> connector area is incomplete.  We have a design group that can probably
> design one like it, but we need input on the connector area
> dimensioning.  Anyone remember that far back?
>
> Anne Ledger
> Manufacturing Engineer
> EMDS, Inc.
> [log in to unmask]
>
>

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################