Hello Technetters,

I am asking a basic question on assembly line.

What percentage of rework (if any)one can expect from a normal
SMT line, Through hole line, mixed assembly line ?

What is the Test Yield(first shot) one can expect from the above lines ?

Thanks in advance,

amith

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################