Hi Technetters,

Anybody using power diodes in a mixed tech. (SMT + Leaded) PCB, single
sided, FR2 material?

What is the Lead Dia to Hole dia ratio normally used by all of you in case
of POwer diodes? Otherwise also what ratio is most oftenly used?

Thanks in advance

Regards
Vinit Verma
Ph: 0124 372721,2,3(O)  Fax: 0124 372724 (O)
    011 7871747 (R)          011 5783571 (R)

--------------------------------------------------------------
Bharti Telecom Limited, Gurgaon, India

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################