Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 4 Dec 1998 14:20:19 -0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi
I have my own opinions on critical features at flowsolder machines but I
would like any other opinions in case I'm neglecting something. To this end
I would like to ask what you consider to be the most important features
involved in getting the best soldering quality from a flow solder machine.
Statistical process control is planned. The machine in question is a
Blundell single wave with foam fluxer.
Parameters being monitored (independently of machine) are bath temperature,
solder contamination levels, and spec gravity of flux. No clean flux is not
being used.
Parameters not being measured (except by flowsolder m/c display panel where
possible)are titration levels of flux, flux application performance (level
check), wave and bath height, lambda, omega, conveyor speed/angle, topside
preheat temp, air knife angle, time motor is on prior to running boards. I
would consider these points worth addressing - any opinions?
Thanks
Bob Gallagher
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|