 
| Mime-Version: |
1.0 |
| Sender: |
|
| X-To: |
|
| Date: |
Tue, 15 Dec 1998 18:00:59 -0500 |
| Reply-To: |
|
| Subject: |
|
| From: |
|
| Content-Transfer-Encoding: |
7bit |
| Organization: |
Applied CAD Knowledge Inc. |
| Content-Type: |
text/plain; charset=us-ascii |
| Parts/Attachments: |
|
|
Jim Gryga wrote:
>
> snip <
>
> If you have any experience or recommendations on stencil aperture
> configurations, stencil technology, paste types, etc., etc, I'm all ears.
Hi, Jim -
Two row connectors can lend themselves to elongated pads
on the stencil, putting more paste "in play".
You're not alone, this style (fine pitch through-hole) can
raise havoc in fabrication and EMI as well, if not properly
anticipated/accomodated in design.
Good luck,
--
Jeff Seeger Applied CAD Knowledge Inc
Chief Technical Officer Tyngsboro, MA 01879
jseeger "at" appliedcad "dot" com 978 649 9800
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|
