Since the spec says to leave them IN,
and vendors like to take them OUT,
why not leave them IN,
and add a note that allows the VENDOR to take them OUT
if they feel they can make the board better by doing so.
That way, they assume responsibility by removing them.
Just a thought....
Jack
-----Original Message-----
From: Leonard Toohey [mailto:[log in to unmask]]
Remove unused pads on vias.
Leave unused pads on through holes that will receive a pin
that
gets soldered.
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################