Hi Technetters,

I have a curious question to ask, regarding the MPM auto-printer.

If there is only 1 set of printer, however, has 10 stencils of
the same kind of openings (Basically all the stencils are the same,
used for only 1 type of PCB's pattern).

If 1 of the 10 stencils is being used as reference for teaching, is
there a requirement to re-teach every single stencil that is loaded
into the printer to ensure the printing accuracy ?



Regards,
Poh

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################