To all netters working to J-Std-001A or B

The scenario....

You have a plated through hole board with 250 solder joints. The boards are
being run in lots of 15 pieces. The boards are wavesoldered. On one board
there is a single solder joint which is a cold solder joint which violates
item 6 of Table 11-1 (Defects). According to the standard, corrective action
must be initiated because this defect exceeds the 0.3% limit imposed in
paragraph 9.1.1..

The questions are..

How is this handled by folks who are required to work to J-Std-001A or B ?

Is "normal" touch up part of the wavesoldering process where this defect
would be cause for corrective action if missed by wavesoldering and touch up
?

Thanks for your help.

PS. Thanks to all respondents to my question concerning the Actel CQ-132
component. Your responses were extremely valuble and helpful. Some folks
really outdid themselves trying to help out. I really appreciate it !

Bill Kasprzak
Moog Inc.

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################