Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 12 Nov 1998 17:30:07 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Neckdown is a term used when a trace needs to be less wide in an area to get
through pad/lands or just for pad entry because of solderability issues.
I.E. say a conductor trace on a board is being routed at .025 wide and you
need to get between two pads that have a .020 clearance between them you
will need to neckdown the trace to say .008 wide. Or you are entering a .062
pad with .10 trace and need to neckdown to say .040 close to the pad for
solderability. Longwinded but basically making a trace less wide for a short
distance to maintain design rule clearance or solderability.
Robert M. Wolfe
-----Original Message-----
From: Tenison Stone [SMTP:[log in to unmask]]
Sent: Thursday, November 12, 1998 4:17 PM
To: [log in to unmask]
Subject: [TN] neckdown
Hi everyone!
We're past the hump for the week, so I hope someone is compassionate
and
will answer a rookie question.
Please describe what "neckdown" is and how it is used.
Thank you for your assistance in advance.
Tension Stone
Telex Communications
Blue Earth, MN 56013
507-526-3205
################################################################
TechNet E-Mail Forum provided as a free service by IPC using
LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|