With a through-hole board, somtimes the masking is nicked, exposing the
copper (bare metal).
What methods - pens, etc. - do others use to touch up the mask? Any
recommendations on specific products (manufacturers) and/or methods?
Thanks for your help.
Bryan Bloom
G&M Assembly
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################