Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 10 Nov 1998 06:59:02 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Jim
Your quoted chapter and verses bring up a question that I have been struggling with. With todays ever
shrinking lines and spaces, what is considered the "minimum electrical spacing"? It seems to me that
different sections of a PWA could have different spacing requirements. How is this spacing being
documented so that the information can be related to production personnel?
Gary Camac
[log in to unmask] wrote:
> Jim: IPC-A-610B is not process dependent. Solder balls, whether formed
> during through hole, SMT, wave solder, reflow or hand soldering are covered by
> par. 4.1 on page 53 of IPC-A-610B. J-STD-001B covers solder balls with Defect
> No. 16 of Table 11-1 (again, not process or technology dependent).
> Hope the above helps some.
> Regards, Jim Moffitt, Moffitt Enterprises Consulting
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
> ################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|