Content-Transfer-Encoding: |
7bit |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Wed, 4 Nov 1998 10:29:22 -0800 |
Content-Type: |
text/plain; charset="iso-8859-1" |
MIME-Version: |
1.0 |
Reply-To: |
|
Parts/Attachments: |
|
|
Hi folks,
I'm looking for sources of information, recommendations, etc. for laying out
epoxy stencils for mounting bottom side surface mount components. Are there
any standards for this? Anyone care to share their ideas, preferences, etc?
Thanks.
Rick Thompson
Ventura Electronics Assembly
2665A Park Center Dr.
Simi Valley, CA 93065
[log in to unmask]
(805) 584-9858 voice
(805) 584-1529 fax
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|