Subject: | |
From: | |
Reply To: | |
Date: | Tue, 24 Nov 1998 18:06:35 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Joe Dickson wrote:
>
> Hello,
> I am reviewing any system designed for cross sectioning vias less
> than 8 mils in diameter. We have all of the current systems (I
> believe) including autogrind/alignment for mounting and are somewhat
> successful, but it is very time consuming.
> I'm looking for a system that will grind down to the center of the
> via +/- .001". Possibly an optical alignment for grinding and
> locating of the via. At the same time we will be upgrading our
> microscope capability to view 500x on our video system. I would like
> to review a tooling system for a new microscope that would be
> compatable with the alignment system.
>
> If you know of a system or sell one please contact me.
>
> Thank you,
>
> Joe Dickson
> Dir. of Engineering
> Tyco Printed Circuits Group
> 400 Mathew St.
> Santa Clara, Ca. 95050
> 408-727-9169
> [log in to unmask]
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
> ################################################################
Have you checked with Struers for the polishing / grinding equipment?
They are the best.
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|