*Hellow there..
I'm working for ROUTING(PCB manufacture)
The PCB user wants the special routing tolerance;+/-3mil(+/-0.076mm)
We should meet the +/-3mil routing tolerance.
And we cannot use only one or two of the routing spindle.
We have the 4-spindle and 2-table CNC routing M/C.
We should use all of the 4-spindle in 1 cycle for productivity
Usually we do route as blow
1.routing stack:3stack
2.routing feed:1.2meter/minute
3.routing RPM(rotation per minute):27000
4.routing bit:2.0mm bit for +/-5mil tolerance
5.PCB thickness:1.27 mm
You can help me like this to meet the +/-3mil tolerance
1.correcting the routing stack by 1 or 2stack
2.changing the routing feed and RPM higher or lower
3.using the special routing bit for the special tolerance
4.changing the CNC routing data(memory)
***please teach me what should i do for the +/-3mil routing tolerance***
your quick respose will be helpful
I'd appreciate any references to relevant literatute also.
Thanks in advance for your thoughts,
Kang Deug Heon
Engineer
Ph. korea 415 861-1525
Fx. korea 415 861-1334
EM. [log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################