Does anyone have a formal visual inspection step for misprinted boards
after they have been cleaned? What do you look for? Are any remaining
solderballs unacceptable? Is there an IPC spec or any other type of spec
that details what to look for in such boards?
Any comments, suggestions would be greatly appreciated.
Best Regards,
Renu Cherian
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################