After an inner layer has come out of the etcher and you find a trace
that is broken, is there anyway that you can repair a copper trace (easy
access to it, i.e., not close to any other traces) that will withstand
the subsequent lamination cycle?

Thanks,

Patty G. Causey / LYPME
Manufacturing Engineering Support
(912) 926-9473 DSN: 468-9473 Fax: (912) 926-7974
email:  [log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################