Ryan

On the components you can not control the length by prepping alone ;
you could use pneumatics for major volumes and exchange only the blades
;
which you can temper as well to your desires .
They're quite cheap considering the ease and volume of the work .
And ; get those blades with clips on lead ; so the cut don't missile
through plant with all sorts of undesirable destinations .

See you
Paul Klasek ;
http://www.resmed.com

> ----------
> From:         Ryan Jennens[SMTP:[log in to unmask]]
> Sent:         Tuesday, 13 October 1998 2:32
> To:   [log in to unmask]
> Subject:      [TN] Cutters
>
> Mornin' all!
>
> We have a problem with our through-hole lead cutters dulling.  They
> are
> the hand-operated type as we are hand-stuffing through hole parts for
> now.  They are just your run-of-the-mill clippers, and I cannot find
> any
> specially hardened versions to last longer.  Our leads are not made of
> any particularly hard material.  Is there a different solution than
> buying new clippers as they wear out? Thanks again.
>
> Ryan
> Phoenix Engineering Design
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV
> 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with
> following text in the body:
> To subscribe:   SUBSCRIBE TechNet <your full name>
> To unsubscribe:   SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
> section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or
> 847-509-9700 ext.312
> ################################################################
>

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################