TECHNET Archives

October 1998

TechNet@IPC.ORG

Options: Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
"Mengers, William D." <[log in to unmask]>
Reply To:
TechNet E-Mail Forum.
Date:
Mon, 5 Oct 1998 15:18:17 -0400
Content-Type:
text/plain
Parts/Attachments:
text/plain (26 lines)
Can anyone suggest a reliable/cost effective method for plugging vias in a
solder coated copper multilayer polyimide board?  The different vias sizes
are approximately .010" and .015" dia. after solder plating.  They are in
ground plane areas where solder will be printed, parts placed and then sent
thru reflow at 215 C.  The part body gets soldered to the ground plane.  We
can't afford to loose an area greater than the diameter of the holes under
each part to nonconductive material.  We are trying to prevent solder loss
thru the holes to the other side of the board.  Whatever material we use
must not expand out the top of the hole to push the part up during reflow.
Thanks for any help you can give in this matter.

Bill Mengers
Process Engineer

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################


ATOM RSS1 RSS2