Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Fri, 9 Oct 1998 12:30:17 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Greetings TechNetters!
My company is able to custom design PWBs with low surface CTE for use in
military / space environments. Then along come the plastic parts. I have
been tasked with determining how to best use ceramic and plastic parts on
the same PWB. As I am a material engineer, I am not that familiar with
component parts and their sources. However, I am all too familiar with CTE
mismatches in general and realize that this is a major part of this specific
problem.
1. What are some good information sources? (Companies, web sites,
papers, etc.)
2. What design issues should I focus on?
3. What board manufacturing issues are there to consider?
4. What assembly headaches are looming in my future?
I would greatly appreciate any and all guidance on these issues.
Thanks in advance!
Terri Neubauer
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|