Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Tue, 8 Sep 1998 16:14:57 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I am a floor shop engineer for a Digital Oscilloscope line. Our PCA's have
mixed technology and down to 20 mil. (typically 25 mil and above).
Typically the boards are 12" X 12" with approx. 10K chances for error (ie.
Comp. Count + Lead Count). Typically 10% of the parts are located on the
secondary side. I would like to know what the industry considers an
acceptable defect rate in PPM coming into a subassembly test department,
after an in-house QA lot inspection, and rate from an outside PCA house.
My QA department has a certain threshold in mind before something is a
"problem". I want to know if their threshold is at least in the ballpark
of the industry. Thank you.
Best Regards,
Mike Forrester
LeCroy Corp.
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|