Here's a basic question, I'm routinely getting soft solder on fine pitch connections (15-25 mils), the solder looks good but is just plain soft. A probe can pop the leads very easily. The boards are almost exclusively surface mount and are built and reflowed with a heat sink covering the entire board attached. I believe the profile to be good or very close. I am washing and baking all boards to lessen contamination issues yet I still see soft solder. Any ideas OK
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################