Hi Everyone,

When creating smt polarised component geometries on your cad system for pcb
design do you create them horizontally with the polarised side to the right
or the left? In other words is there a standard for this when creating
PCB footprints?

Best Regards,
Paul Arklay

Jtec Pty Limited
Unit 3
118-122 Bowden Street
Meadowbank NSW 2114
Sydney Australia

Switch +61 2 98096933
Fax      +61 2 93640055
Direct  +61 2 93900622

[log in to unmask]

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################