We have recently started using stencils to apply glue to the bottom side of
our boards (as opposed to glue dotting) prior to pick & place.  The problem
is that we do not have a good source of information, i.e. stencil patterns
for given component footprints.  Does anyone know where more can be found
on this subject? And if so, point me in the right direction.  Thanks in
advance for any helpful suggestions.

Scott Trudo

Printed Circuit Board Designer
Philips Broadband Networks, Inc.
100 Fairgrounds Drive
Manlius, NY  13104
Phone: (315) 682-9105
Fax: (315) 682-2279
E-mail: [log in to unmask]

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################