Sender: |
|
Subject: |
|
From: |
|
Date: |
Wed, 16 Sep 1998 07:48:12 -0700 |
Content-Type: |
TEXT/PLAIN; CHARSET=US-ASCII |
MIME-Version: |
1.0 |
Reply-To: |
|
Parts/Attachments: |
|
|
This is very helpful, I appreciate your response as well as everyone else who
has responded.
Thanks again,
Mike
On Wed, 16 Sep 1998 04:34:08 -0700 Hoppa, Floyd wrote:
> From: Hoppa, Floyd <[log in to unmask]>
> Date: Wed, 16 Sep 1998 04:34:08 -0700
> Subject: [TN] Flux Measuring Techniques
> To: [log in to unmask]
>
> One method we use for this measurement is a specially designed carrier
> with (4) glass plates in slots held down by spring clamps. These plate
> glass pieces are removable. The following steps are then taken:
> 1) We will wash the plate glasses and pallet.
> 2) Weigh the (4) glass plates separately and record the weight.
> 3) Assemble the glass plates into the pallet.
> 4) Run the pallet down the wave solder machine (chip wave and
> wave bath are off)
> 5) Remove the glass plates and weigh in the scale. Record the
> data.
>
> The scale is measuring (or attempting to measure) micrograms. We use a
> Ainsworth 1000 scale (which run approximately ($70,000). We will run
> several tests to see if it is repeatable and consistent.
>
> Hope this helps.
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
> To subscribe: SUBSCRIBE TechNet <your full name>
> To unsubscribe: SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
> ################################################################
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|