Mime-Version: |
1.0 |
Sender: |
|
X-To: |
|
Date: |
Tue, 15 Sep 1998 18:50:43 EDT |
Reply-To: |
|
Content-type: |
text/plain; charset=US-ASCII |
Subject: |
|
From: |
|
Content-transfer-encoding: |
7bit |
Parts/Attachments: |
|
|
In a message dated 9/15/98 2:49:29 PM Pacific Daylight Time,
[log in to unmask] writes:
<< For BGAs, particularly CBGAs, a reflow profile with a
peak temperature of 219C is too low even for eutectic Sn/Pb solder.
Even with high-melt solder balls you should get nice fillets because of the
eutectic solder paste.
The reliability of the solder joints goes up roughly with the square of the
stand-off height. >>
Really? Hmmmmm...I've always tried to peak out between 210 - 220
degrees...have I been wrong in doing that? What I thought defined a good
generic profile was;
1.) Ramp no more than 2-4 degrees per second.
2.) Dwell for around 1-1.5 minutes at roughly 150 degrees C. to activate the
flux and allow everything to come up to temperature together and stabilize.
3.) Ramp a second time to reach 20-30 degrees above the liquidous and hold
that for at least 30 seconds, but try to limit it to 1-minute, and don't peak
over 220-degrees C..
That's REAL general...but that's what I've always understood to be good basic
guidelines for a reflow profile. What should I be peaking at? Is what I
thought to be good guidelines passe' now? Am I really hosed up?
I have read lately, that "stepped" profiles really aren't necessary. I've
read, that you'll get better results with just a gradual, linear rise to peak
temperature, then cool. 'Course I know everything depends on your paste
formula and ingrediants, but speaking in general terms where am I off-base?
-Steve Gregory-
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|