Hello all,

I know there have been some discussions on flex delamination, but I was
wondering what the acceptibility criteria were for assemblies. I know there
are several bare board acceptance documents that talk about it, but I
haven't seen anything about what to do once boards are built. If anyone has
any ideas about this, or if they know where to find any documents with info
about this, please let me know.

Thanks,
Matt

Matthew Sanders
PWB Procurement Engineer, Trimble Navigation Limited
[log in to unmask]
Phone: (408) 481-7817
Fax: (408) 481-8590

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################